Cellphone-Mate CM2000 40dB Wireless Amplifier Kit - NOMAD V3.0

Cellphone-Mate CM2000 40dB Wireless Amplifier Kit - NOMAD V3.0

Dropped calls? Boost and increase your cell phone reception with this complete system: Cellphone-Mate CM2000 40dB Wireless Amplifier Kit - NOMAD V3.0! Wilson has been known for their state of the art wireless communication technologies which have improved and changed the quality of conversation for countless numbers of people.

Whether you're at home or at the office, as long as there is low signals, the Cellphone-Mate CM2000 40dB Wireless Amplifier Kit - NOMAD V3.0 provides a sizable indoor coverage for most home and office environments.

Do you need custom designed amplifier system at your place? Fill out AccessoryGeeks Cell Phone Signal Site Survey right here.

Kit is best for: [ Car - Personal Area - Office]

• Dual Band Coverage for most US Cell PhoneProvider (T-Mobile, AT&T, Verizon Wireless, Sprint, etc - excluding Nextel iDEN)
• Wireless operation with multi user support
• Improve data card and broadband signals too
• No technical experience required - Plug-and-play style installation / AccessoryGeeks' Cell Phone Signal Booster Installation Guide provided
• Better signal mens longer battery life
• Attractive, sleek design
• FCC approved
• Model #: CM2000-WL40DBV3
• **Difference from Wl40db is better Heat Sync and comes with a switch.

Optimal Operation Requirement for any Cell Phone Signal Boosters

• Distance of separation for Cell Phone Signal Booster
• Signal availability outside your home/office/warehouse (at least 1 or 2 bars, 3 bars to be optimal). Remember, no signal outside = no signal inside even with amplifier

• 1x CM2000-WL40DBV3 40dB Amplifier
• 1x Indoor rubber Antenna
• 1x Exterior rubber Antenna Patch for Indoor with 12 feet lead cable
• 1x Small outside antenna with 15 feet lead cable
• 1x SMA male to FME male Adapter for External Antennas
• 1x SMA male to N female Adapter for External Antennas
• 1x 12 V DC adapter
• 1x 110V AC Power Transformer

Need more help?

AccessoryGeeks Exclusive Cell Phone Signal Booster Installation Guide	AccessoryGeeks Exclusive Cell Phone Signal Booster General Package Content Guide

General specifications For Cellphone-Mate CM2000 40dB Wireless Amplifier Kit - NOMAD V3.0


Frequency Range	Uplink: 824-849 & 1850-1910 MHz Downlink: 869-894 & 1930-1990 MHz
Standard Supported	All major standards include: CDMA, GSM, TDMA and AMPS
Gains	Cellular 40dB / PCS 45 dB
Maximum RF Output Power	3 Watts EIRP
Impedance	50 ohms
Noise figure	Maximum 5dB
VSWR	Typical value 2:1
AC power transformer	Input: AC110V, 60Hz; Output: DC6V
RF Connectors	FME Male
Power Consumption	< 10W
temperture	-20 degrees to +70 degrees C
Dimension	7 x 4.8 x 1.2 inches

A BRIEF INTRODUCTION

Reference [ CELL SIGNAL CALCULATOR ] & [ FAQ - A.G. AMPLIFIER'S GUIDE ]

What is the Distance of Separation required for a Cell Phone Signal Booster?

Distance of separation is the separation needed for an amplifier kit to work properly. If the distance of separation is too short, the amplifier kit will not work to its fullest potential. Think of it as microphone feedback; when you place a microphone too close to the speakers it will give you a screeching noise feedback. Keep in mind that a vertical separation (diagonally going up) helps shortened the total distance of separation required. Refer to the table below when designing your kit.

Amplifier Type	Distance of Separation	Best Application	Look for these icons
40dB	5-10 feet	Car or desk space
45dB	5-15 feet	Car, truck, or desk space
50dB	25-45 feet	Small office, 1 room in the house, trailers, or boat
55dB	45-55 feet	Small office, 1 room in the house, trailers, or boat
60dB	50-60 feet	Office, large room, small warehouse
62dB	60-70 feet	Office, large room, small warehouse
65dB+	70-100 feet	Large office, mansions, or warehouse

This particular kit requires at least 5ft of separation like shown on the diagram below:



Cellphone-Mate CM2000 40dB Wireless Amplifier Kit - NOMAD V3.0

TIDFV

Disclaimer:

• *Life Time Warranty available with Cellphone-Mate

Cell phone signal boosters only work in situations where there are traces of signals. Systems will not work if zero signals can be picked up.

Accessorygeeks.com is not responsible for loss or damages caused by delays in delivery from natural disasters, manufacturer delays, acts of war or other causes beyond our control.




Cellphone-Mate CM2000 40dB Wireless Amplifier Kit - NOMAD V3.0

Order the Cellphone-Mate CM2000 40dB Wireless Amplifier Kit - NOMAD V3.0 today! Don't miss out on this great deal with Free Shipping. The Cellphone-Mate CM2000 40dB Wireless Amplifier Kit - NOMAD V3.0 is ready to be shipped within 24-48 hours.

Let the Geeks Experts help you with any questions or concerns. Call us today at 1-866-433-5793 or email us at CS@AccessoryGeeks.com.

Buy the Cellphone-Mate CM2000 40dB Wireless Amplifier Kit - NOMAD V3.0 today at AccessoryGeeks.com

• This Dual Band Cellular Amplifier Kit does not work for Nextel.
• This Dual band cellular amplifier kit works for Canadian GSM, CDMA, PCS carriers.