MOTOROLA RAZR V3 FACEPLATE INSTALLATION

1. Turn the phone off.
2. Flip open the phone and remove the four rubber plugs on each corner of your LCD screen to reveal the screws.
   *We recommend using a thumb tack to remove the rubber plugs.
3. Use a Torx 5 (T5) screwdriver to remove the screws.
4. At this point, the faceplate has clips which keeps it attached to the phone.
5. There are 6 clipped points that must be detached in order to remove the faceplate:
   1. Two points are located beside each other at the top of the phone just above the camera lens.
   2. Another two points are located half way down the face on either side.
   3. The last two points are evenly spaced at the bottom of the face.
6. Now your new faceplate is ready to be installed. Follow the steps backwards to install the faceplate.
7. Start by attaching the new faceplate onto the face of the phone by snapping it into position.
8. Drive the screws into position and re-attach the rubber plugs.
9. Remove the battery door and swap with the new battery door.