The Wilson Glass Mount Outperforms the Competition. Engineered and Made in the USA.
Features & Highlights
Why you should buy this product
The Wilson Glass Mount Outperforms the Competition.
Engineered and Made in the USA.
Up to 90% of a cell phone's power on transmit and receive is absorbed within a vehicle and the users head. We solve this problem by channeling all the power from the cell phone to the outside antenna. This results in our glass mount antenna transmitting and receiving over 10 times the signal of a cell phone used inside a car / truck without an outside antenna.
The Wilson Glass Mount Cellular Antenna was carefully designed to minimize loss and maximize gain on both the 800 MHz and 1900 MHz bands. Wilson accomplished this by using a phasing coil and a low loss coaxial phase reversing device that provides high gain on both frequencies. Wilson's innovative design results in high efficiency with low losses and will get the most signal to your cellular phone. Thanks to these innovations and our attention to detail Wilson Electronics has the best performing glass mount cellular antenna booster available.
The Wilson Glass Mount Cellular Antennas main benefit over our other dual band antennas is its ability to pass its signal through single pane glass. This allows for very clean looking permanent installations in which the cable is hidden. Wilson Antenna's are made in the USA.
The Wilson Nextel / iDEN Cellular Antenna (NX800) is the most advanced cellular antenna of its kind. Few things are as frustrating or dangerous as trying to reconnect a dropped call while driving. The Wilson Nextel / iDEN Cellular Antenna dramatically or completely eliminates cell phone disconnections and noise. Inside of an automobile a phone with The Wilson Nextel / iDEN Cellular Antenna can transmit and receive over ten times the signal of a phone without one. In addition to dropout and noise reduction, The Wilson Nextel / iDEN Cellular Antenna eliminates microwave energy radiating into the head. This is achieved by channeling all the energy out though the external antenna.
Requirements (sold separately) Cell phone adapters Amplifers / repeaters Coaxial Cables
Specifications Electrical Properties: Part #: 304001
Impedance: 50 Ohms / Both Bands
Antenna Gain: 4.5 dBi 806 - 894 MHz
5.9 dBi 1850 - 1990 MHz
System Gain: 10-15 dB (More Than 10 Times the Signal) of a cell phone used inside a car / truck without an outside antenna.
Wavelength: 1.1 Wavelengths 806-894 MHz
2.3 Wavelengths 1850-1990 MHz
Ground Plane: Built in Ground Plane Mechanical Properties: Connecter: FME-Female
Material: Whip - Stainless Steel
Coax Cable: RG58 / 14'
Mount: Glass Mounting with 3M Adhesive
-Tuned for Maximum Performace on Nextel / iDEN Frequencies (806-821 MHz Tx & 851-866 MHz Rx)
-Glass mount antenna booster significantly increases your cell phone's range on send and receive.
-Helps eliminate the dreaded "Dead Zones."
-Installs in minutes without tools.
-No power required.
FAQs - Click Here for more information on Antennas and Amplifiers.
You Might Also Be Interested
Customers Who Viewed This Item Also View